MKS-GEN V1.4 Controller Mainboard+MKS TFT32 LCD Display+6Pcs Limit Switch+5Pcs 4988 Driver Kit For 3D Printer

Tax included.

Regrading MKS GEN-L:

1. Fully consider stability, heat dissipation, ease of use, continuous print reliability testing

2. Supported 3d printers include Prusa Mendel, ultimaker, printbot, makerbot, etc.

3. The maximum current is 2.5A. Up to 32 segments are supported.

4. 4-layer PCB board for better heat dissipation.

5. The internal resistance of the chip is smaller, the heat is lower, and the heat dissipation is better.

Regrading TFT32 Display:

Appearance size: 110mmX65mm

Hole size: 102mmX57mm

Color touching screen: 3.2 inch

Microprocessor: 32-bit STM32 processor

Support storage system SDcard, U-disk

Update method: SD file update

Support file format: Gcode

Extensible module (not included in delivery): WIFI module, shutdown module, break detection switch, power failure, external card slot

Regrading A4988 Motor Driver:

1. It is suitable for driving motors below 8V-35V 2A.

2. Five different step modes: full, half, 1/4, 1/8 and 1/16.

3. The adjustable potentiometer can output the maximum current output for a higher rate.

4. Automatic current decay mode detection/selection.

5. Overheat shutdown circuit, undervoltage lockout, cross current protection.

6. Ground short circuit protection and load short circuit protection.

Regrading Limit Switch:

- Plug and play

- Normally open mechanical limit switch

- Compact, Portable

- With trigger indicator

- With cable

Note:
The A4988 drivers will be sent in random color (green or red)

Package Included:

1 x MKS GEN V1.4

1 x TFT32 LCD Display

5 x A4988 Drivers

5 x Heat Sink

1 x USB Cable

6 x Limit Switchs

6 x Switch Cable