2WD Tracking Smart Robot Car Chassis Kit With Reduction Motor
Tax included.
Specifications:
1.Photoresistor (LDR) based line following
2.Individual wheel control
3.Chipset: LM393
4.Material: Electrical components
5.Color: See picture
6.Board Size:10.4*7.2cm
The assembly steps:
Note: The battery is not included.
Package Included :
1 x Base board
1 x 35mm Wheels
1 x Rubber Wheel bands
1 x AA Battery holder
1 x Screw set
1 x LM393 Chipset
1 x 8pin DIP Socket
10 x Resistor
2 x Gearded DC Motors
2 x Electrolytic capacitor
2 x Light dependant resistors
2 x Transitors
2 x White LED
2 x Red LED
1 x Power switch
4 x 70mm Leads
1.Photoresistor (LDR) based line following
2.Individual wheel control
3.Chipset: LM393
4.Material: Electrical components
5.Color: See picture
6.Board Size:10.4*7.2cm
The assembly steps:
Step 1: Welding circuit
- Electric welding part is simpler, welding sequence according to the principle of component level from low to high, the first welding eight resistance is important to use the multi meter to confirm resistance is correct
Step 2: Mechanical assembly
- The red line is connected to the 3V positive power supply, the yellow line grounding, the excess wire can be used for the motor wire.
Step 3: The installation of a photoelectric circuit
- Photosensitive resistance and light-emitting diodes (note polarity) is reverse-mounted on the PCB, and the ground distance is about 5 mm, both photosensitive resistance and light-emitting diodes are 5 mm distance. Finally, you can power test.
Step 4: Vehicle debugging
- The right direction is along the universal wheel direction if you press and hold the left photoresistor
- The wheels on the right side of the car should be rotated. Press and hold the right photoresistor
- The wheels on the left side of the car should be rotated, if the car driving back, can alsoexchange the wiring of two motors, if the one side normal and the other side back up, as long as you can swap wiring on the back side.
Note: The battery is not included.
Package Included :
1 x Base board
1 x 35mm Wheels
1 x Rubber Wheel bands
1 x AA Battery holder
1 x Screw set
1 x LM393 Chipset
1 x 8pin DIP Socket
10 x Resistor
2 x Gearded DC Motors
2 x Electrolytic capacitor
2 x Light dependant resistors
2 x Transitors
2 x White LED
2 x Red LED
1 x Power switch
4 x 70mm Leads