K212 Switch Power Supply Fingerprint Access Control Control Board Door System

·Power supply: DC8--30V,

·Stand-by mode current:40mA

·Fingerprint capacity: 200

·Interface output of motor: ±DC5V,300mA

·Interface output of relay: 3A

K202 is designed for low power consumption, the power supply is DC12V, the relay time can be adjusted by rotating the button, relay time: 0.5-13 seconds.

It is very easy to register fingerprint, just need to press SET button to register fingerprint and long press SET button to back to factory default.

P1：Power supply, Input voltage: DC8--30V, Input current: 0.3A 

P2：Relay output

P3：Active Signal of open door, Voltage DC12V(Input)

P4：Fingerprint module(Input) 

P5：Micro-motor(Output) 

P6：Button for opening door, closing signal(Input) 

Adjustable resistance: Setting closing time for relay

1. System on working state, indicator light(LED) flash slowly.

2. Press SET button, system in register state and indicator light flash fastly.

3. Fingerprint can be registered continuously when system in register state; if no need for adding fingerprint more, exit after waiting 5 seconds or by press SET button;

4. When back to factory default, press RESET button until hear?œDi?? release the button, hearing ?œDi??long beep means operation successful;

5. Fingerprint verified or the button for opening door closed, the relay actuated,the relay time can be set by adjustable resistance, setting time:0.5-9 seconds; Motor interface output DC5V and keep 0.5 seconds; stop 5 seconds, then minus voltage outputted and keep 0.5 seconds.

1 x K212 Switch Power Supply Fingerprint Access Control Control Board