AC90V-260V Input DC110V Output 8A PWM DC Motor Speed Controller Driver Speed Governor

 

* Material: Metal

* Ambient air temperature: -10 ~ 40 ° C

* The air relative humidity of 85% or less, well-ventilated

* The input power supply (VAC): AC90-260V 50 / 60Hz (for global voltage)

* The output armature voltage range (VDC): DC110

* The output armature current range (A): 8A (0.1A-10A can be arbitrarily set)
 

* The output excitation voltage range (VDC): 100/200 (default full-bridge rectifier, which is 0.9 times the input voltage) 5, the output excitation current range (A): 1A

* The working frequency: 16 KHz

* Given signal mode (V / mA): default potentiometer, 0-5V, 0-10V, 4-20mA, PWM, touchtone

* Enable control mode (EN): switch

* Soft start (acceleration time adjustment range) (S): 0-10S (default 2 seconds)

* Soft stop (deceleration time adjustment range) (S): 0-10S (default 2 seconds)

* Double loop PI regulation (voltage and current) control is more reliable

* IR torque compensation range: 0-100% (default 0)

* Overcurrent range: 0 setpoint (default 8A)

* Overcurrent mode: stop output and indication (display code E1)

* Short-circuit protection: stop output and indication (display code E0)

* Overheat protection: power tube temperature exceeds 100 ° off the output and the indication (display code E2)

* Built-in digital display module can display real-time operating voltage with current

* Dimensions (approx.): Length 140mm × Width 98mm × Height 38mm 

* Connection: terminal type (convenient)

* Installed in a well-ventilated, no severe impact, no vibration, no explosion dangerous media and no case of conductive metal particles

 

1, the default PWM signal level is 5V, the signal frequency 1KHZ above, with a load capacity of more than 0.5MA.

2, 5V level without resistors in series with PWM input port,

   10V PWM level from 0-10V input port or serial port 10K resistor in the PWM input,

   12V level 3.9K resistor string from 0-10V input port or serial port 13.7K PWM input resistors,

   24V level string 27K resistor from 0-10V input port or serial port 16.8K resistor PWM input

 

* Using pulse technology to speed more stable, low speed forceful.

* With a short circuit, overcurrent, overtemperature protection cutoff device to make more reliable performance.

* With the elimination of soft starter motor starting current is too large.

* High and low voltage signal is completely isolated, the use of safer.

 

 

 

* The governor closed the input power,Touched by hand within a minute ban high-voltage terminal,There are high-voltage capacitors,To prevent electric shock!!!

* For the two lines of DC permanent magnet motor,Two lead wires connected directly to the armature M + with M-.Prohibit access exciting!

 

1. Please allow a bit error due to manual measurement. please make sure you do not mind before you bid.

2. The color may have different as the difference display, pls understand.