English Version N1201SA+ PLUS UV RF Vector Impedance SWR Shortwave Antenna Analyzer Meter Tester 35 MHZ-2.7GHz
Tax included.
Specifications:
This instrument has four interfaces: single point measurement, scanning, system information, correction and calibration
The default boot into single-point measurement interface.
Note: For the convenience of the user, each time calibration correction options will automatically change to the user calibration. Meanwhile, in order to ensure the integrity of the calibration, the calibration process, the automatic shutdown function fails, the consistent boot.
Startup and shutdown
Hold down the CTRL key off press the power switch button.
The boot state, long press (2S above) the switch button, after the release, the instrument will shut down
The boot state, long press (2S above) the switch button, after the release, the instrument will shut down
Recommend the use
1, in order to ensure the accuracy of measurement and calibration, preheat the instrument at least 15 minutes.
2, try to use good quality RF cable and connectors.
3, calibrated cable marked to the next may not need to calibrate and direct use.
4, test cable process affect the measurement accuracy, it is recommended that, where possible, do not choose too long test cable.
5, measurement and calibration before, make sure you are not in a strong wireless signal, so as to avoid interference caused by inaccurate measurements.
6, if the impedance measurements themselves do not understand, you can refer to a vector network analyzer instructions and tutorials. This instrument is equivalent to a single-port vector network analysis.
Note: press the second key and the fourth key at the same time to turn on the machine
N1201SATechnical index | ||
working frequency |
35MHz~ 2700MHz |
|
Frequency step |
1kHz |
|
Monitor |
2.4TFT resolution 320& times; 240 (QVGA) |
|
Battery capacity |
2000mAH(7.4Wh) |
|
Power consumption |
<1.5W |
|
Charging current |
400mA |
|
Charging interface |
USB(Temporarily as a charging interface, data transfer is not open |
|
Automatic shutdown |
Can be set (always open, 5 minutes to 60 minutes) |
|
Measurement parameters |
||